How To
How To
114 results
-
Yes, the Y50BT volume controls are located on the bottom of the right ear cup. You also have the power/pause/play and track controls located on the bottom right ear cup of the headphones.Was this helpful? Thank you for your feedback!
-
Yes, the cable is detachable.Was this helpful? Thank you for your feedback!
-
You will not be charged for ground shipping. Expedited shipping costs are based upon total weight and service availability.Was this helpful? Thank you for your feedback!
-
We do not ship internationally.Was this helpful? Thank you for your feedback!
-
If you are experiencing issues getting the app to communicate with your headphones, (assuming you have already paired the headphones with the device) go into the communication apps audio settings. You will likely find the resolution there. You may have to set your headphones as the ‘communication device’ within the app you are using.
Was this helpful? Thank you for your feedback! -
The returned merchandise will be inspected when it arrives at the warehouse. When all is confirmed, we will transfer the amount payable back to your credit card.Was this helpful? Thank you for your feedback!
-
The red diode that lights up when charging begins will go out again when charging is complete.Was this helpful? Thank you for your feedback!
-
Here is the pairing procedure between a K915 headset and a new transmitter box: 1. Power off the headphone. 2. Power off the transmitter. 3. Press and hold the power button on the headphone until the “Signal” LED is flashing, and a beep sound can be heard. 4. Power on the transmitter. 5. After a short while the “Signal” LED will light constantly (stop flashing) and the pairing is complete.Was this helpful? Thank you for your feedback!
-
On the Right ear cup, slide the bluetooth button towards the down position and hold until you see the fast blinking blue LED light. Make sure that the device that you are trying to connect to is in pairing mode. It should recognize the N60NC Wireless within a few seconds. You should here the audio "chime" when it is connected and the LED should change to a slow blinking light.Was this helpful? Thank you for your feedback!
-
The best way is to carefully insert your nail in the groove where the two halves of the plug meet, then press into the groove until the two sections separate. If you pull on the cord, you may damage the cable by dislodging the cable from the plug.Was this helpful? Thank you for your feedback!
-
The red light in the charging status LED on the right cup will turn off.Was this helpful? Thank you for your feedback!
-
The L and R that indicate the two channels are located on the soft grommets that protects the signal cable where it enters the headphone shell. The letters are recessed into the grommets, and are very small. If they are too difficult to read, it may be easier to simply observe how the headphones are situated in the ears. The oval body of each in-ear, with the chrome stripe, should be away from the head, and be situated in the ear lobe, not stick out directly from the head.Was this helpful? Thank you for your feedback!
Can’t find what you’re looking for?
Call Us
Talk to a product expert
Call us now at:
(800) 336-4525
Mon - Fri: 9:00 am - 11:00 pm (EST)
Sat - Sun: 9:00 am - 5:00 pm (EST)
Chat With Us
Mon - Fri - 9:00 a.m 11:00 p.m (E.T)
Sat - Sun - 9:00 a.m 5:00 p.m (E.T)